3x WAGO terminal through connector

With these WAGO terminals, the Resler module can be easily installed in the wiring harness of an Android radio. There is no need to install the module/interface by soldering.

Installation:

1. Partially expose wiring harness from fabric tape
2. Find out correct pin numbers on quadlock connector (see wiki)
3. Cut cable for +12V, ground and I-BUS at the cable harness
4. Strip both ends of wiring harness and cable from module 11 mm each
5. +12V, ground and I-BUS cable from one side of the harness and from module well twisted
6. Insert cable ends for +12V, ground and I-BUS from both sides into the terminal as far as it will go and close the terminal.
7. Check by pulling lightly if everything is seated securely

 To use the I-BUS app, the Resler module and an app license are also required.

Here you can find a list of all functions of the app