3x WAGO terminal through connector

Tento produkt není v současné době k dispozici.
Prosím informujte mne, jakmile produkt bude opět k dispozici.

3,50 € *

Ceny incl. DPH plus náklady na dopravu

Dodací lhůta cca 5 pracovních dnů

  • WAGO01
With these WAGO terminals, the Resler module can be easily installed in the wiring harness of... více
Informace o produktu "3x WAGO terminal through connector"

With these WAGO terminals, the Resler module can be easily installed in the wiring harness of an Android radio. There is no need to install the module/interface by soldering.

 

Installation:

  1. Partially expose wiring harness from fabric tape
  2. Find out correct pin numbers on quadlock connector (see wiki)
  3. Cut cable for +12V, ground and I-BUS at the cable harness
  4. Strip both ends of wiring harness and cable from module 11 mm each
  5. +12V, ground and I-BUS cable from one side of the harness and from module well twisted
  6. Insert cable ends for +12V, ground and I-BUS from both sides into the terminal as far as it will go and close the terminal.
  7. Check by pulling lightly if everything is seated securely

 

 

 To use the I-BUS app, the Resler module and an app license are also required.

 

Here you can find a list of all functions of the app

 

Scope of delivery: 3x WAGO 221-2411 (Resler module / Resler USB I-BUS interface or... mehr

Scope of delivery:

  • 3x WAGO 221-2411

(Resler module / Resler USB I-BUS interface or cable harness are not part of the scope of delivery)

Video for installation: mehr

Video for installation:

Číst, psát a posoudít hodnocení... více
Zákaznické ohodnocení pro "3x WAGO terminal through connector"
4. 12. 2023

Rapide pour ceux qui ne veule pas souder

Rapide pour ceux qui ne veule pas souder, les contacts se font correctement et ça ne bouge pas.

Napsat hodnocení
Hodnocení bude aktivováno po ověření.

Pole označená * jsou povinné.

Sticker "I-BUSApp" 22 x 3,4 cm Sticker "I-BUSApp" 22 x 3,4 cm
Obsah 1 Stück
3,00 € *
Gift card Gift card
Od 15,00 € *