Accessories

High-quality and color-intensive window sticker in white and orange. Designed as a cut sticker with single standalone characters. Features: Length: approx. 22 cm Height: approx. 3.4 cm Weatherproof and UV-resistant, exterior adhesive....

High-quality and color-intensive window sticker in white and orange. Designed as a cut sticker with single standalone characters. Features: Length: approx. 22 cm Height: approx. 3.4 cm Weatherproof and UV-resistant, exterior adhesive....

This CAN bus interface allows the communications between the I-BUS/K-CAN App and your vehicle. The CAN bus interface can be connected in addition to our Resler interface/module and the Deep OBD adapter and add further functions to these....

Thermal oil level sensor, engine oil level sensor. This oil level sensor was connected to a light module by us and tested for correct function. So you can be sure that this sensor works correctly and a display of the oil temperature and...

Cover cap for screws on E39 radios The covers for the screws of the radios for the BMW E39 (e.g. IQ7239B, PQS7139B) unfortunately get lost quickly. We therefore offer you here the possibility to purchase these covers individually. You...

OBD2 Bluetooth-Adapter for app "Deep OBD" This Xtrons Bluetooth OBD adapter has been converted and tested for the app " Deep OBD " by the app developer Mr. Holeschak. This makes the adapter compatible with all BMW vehicles with OBD2...

With these WAGO terminals, the Resler module can be easily installed in the wiring harness of an Android radio. There is no need to install the module/interface by soldering. Installation: Partially expose wiring harness from fabric tape...

Protection cover for USB plug For example, for the Resler module when used as a "stand-alone" device without Android radio to protect the USB plug from dirt or electrical contact. Can optionally be used as transport protection or...

With this adapter the Resler Module / Resler USB I-BUS Interface can easily be connected to the wiring harness of an Android radio. The installation of the module / interface by soldering is not necessary. IMPORTANT: This adapter only...

This connection cable is necessary to connect the audio signal of the original 6-disc CD changer to the original DSP amplifier via COAX cable (digital). With this cable, the CD changer can be connected directly to the DSP power...

This extension cable is required to extend the FM/AM radio signal from the luggage compartment to the radio slot if a navigation system is installed ex works. The angled plug has the short design to ensure that the radio should fit...

This adapter cable is needed to adapt the FM/AM radio signal from the original ISO connector on the radio to the FAKRA connector for aftermarket radios. The ISO connector is usually present on radios with the old connector (BM24 with OG...