Prix dont TVA plus frais de port
Délai de livraison env. 5 jours
- Réf. d'article : WAGO01
With these WAGO terminals, the Resler module can be easily installed in the wiring harness of an Android radio. There is no need to install the module/interface by soldering.
- Partially expose wiring harness from fabric tape
- Find out correct pin numbers on quadlock connector (see wiki)
- Cut cable for +12V, ground and I-BUS at the cable harness
- Strip both ends of wiring harness and cable from module 11 mm each
- +12V, ground and I-BUS cable from one side of the harness and from module well twisted
- Insert cable ends for +12V, ground and I-BUS from both sides into the terminal as far as it will go and close the terminal.
- Check by pulling lightly if everything is seated securely
Scope of delivery:
- 3x WAGO 221-2411
(Resler module / Resler USB I-BUS interface or cable harness are not part of the scope of delivery)